9/19/2023 0 Comments Meshlab fix non manifold![]() The object will then print with misaligned layers from that point forward. ![]() This is because the hard mechanical stops (screws, and metal edges of the print space) and/or limit switches of the printer will be hit, causing the print head firmware to adjust the center print point by several mm in the opposite direction. But, when printing large objects which are the full width, ex: a 75mmx75mm circle, the object will get destroyed once the max diameter portion of the circle is reached. When printing large objects up to 100mm in height, it seems to work fine. This results in print sheering and possibly damage to the stepper motors or gears.Ģnd, the digital bed size of the ToyBox 3D printer (when you go to load an object to print) is 75 x 80 x 100 mm (7.5 x 8.0 x 10.0 cm). Between 60% and 80% done, it's so tall that the nozzle will eventually catch on the ball edge, tip it over, and then get jammed against it, causing it to think it hit the edge of the print volume, and forcing the center point to shift several mm in the opposite direction. Without them, this ball will not print properly. 2023: the maximum usable print volume of the ToyBox 3D printer is approximately 74 x 79 x 100 mm (width x length x height), and you must add supports to keep tall objects from tipping over and catchingġst, you must add supports to keep tall objects from bending over and catching the nozzle, like this: I have also split the model (to cut the last few cm off the end and shorten it) using this technique here in TinkerCad, then exported the part as a shorter part so I could print on the smaller bed of the ToyBox printer. Note that I have printed many ToyBox-designed models perfectly with this printer over the last 24 hrs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |